Salad Survivor v01
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is for the supermarket salads with a root system in a square of soil.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 1
- Makes
- 0
- Views
- 50
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
New version: Salad Survivor v02
The most common sizes I've encountered were a bit smaller than 8 cm and 6 cm, cubed. The upper 2 cm of the soily squares are mostly free of roots. It is also important to keep the most outer leaves from any pressure of the container to keep the leaves supplied with water and alive. Thus, I've made it both times 4 cm tall, to leave some air. The ramp on the side is to refill and perhaps check the water levels.
So far I've made two sizes. Leave a comment if you want me to add any.
Print instructions
Print in PETG for water-tightness
Print with >= 3 perimeters
No support
I've used 0.2 mm layer height with a 0.4 mm nozzle
Sizes
Version with 8 cm x 8 cm x 4 cm.
Version with 6 cm x 6 cm x 4 cm.
License
You must give appropriate credit
If you remix you must distribute under the same license: Creative Commons — Attribution — Share Alike