Filament Holder IKEA Stuva + Plasta
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament Holder for IKEA Stuva + Plasta
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 9
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As a bar I have used the "Stuva Grundlig" from Ikea.
But you can also use another tube or rod with a diameter of 1.5cm.
Should you also want to use it in Stuva cabinet I recommend a length of 55cm.
you can also use the bracket for other cabinets, then simply adjust the length.
The holes match those of Stuva and should also fit in Plasta, but that I can not confirm to 100%.
Furthermore, I have also added a square version if you want to use a board or square tube.
It is best to use small screws with a flat head, screws with a countersunk head could split the print if you screw it in too deep. I used 3.5 x 20mm screws with a countersunk head and it holds without problems even though I have not screwed them all the way in.