Minimal Magnet Housing (pressfit - no glue)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple Magnet Housing for 10 x 1 mm neodymium magnets for pressfit
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 47
- Makes
- 0
- Views
- 355
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
[EN]
To be able to remove the small neodymium magnets from the fridge with bare hands I designed this small housing. Because of the conical design it is very easy to grab the magnets. The tight tolerance keeps the magnet in the housing without any glue.
Magnet dimensions:
- diameter = 10 mm
- height = 1 mm
Magnets need to be pushed inside the housing with quite some force. (picture) I recommend using a pliers wrench because the yaws stay always parallel so that the force is distributed eavenly. Then the magnet will not tilt or break while pressing it into the housing.
Attention! If you want to stack the magnet, like on the picture you have to make sure they have the same polarity direction before you push them in the housing! If they are inside the housing it is difficult to remove them without destroying the housing.
[DE]
Minimalistisches Magnetengehäuse (Pressitz - kein Kleber)
Damit ich die kleinen Neodymmagnete mit bloßen Händen vom Kühlschrank abbekomme habe ich diese kleine Gehäuse entworfen. Durch die konische Form ist es sehr einfach den Magnet zu greifen. Mit der engen Toleranz halten die Magneten ohne Kleber im Gehäuse.
Magnetmaße:
- Durchmesser = 10 mm
- Höhe = 1 mm
Die Magnete müssen mit einiger Kraft in das Gehäuse eingepresst werden (Siehe Bild unten). Dazu eignet sich ein Zangenschlüssel, weil hier die Greifbacken parallel bleiben und die Kraft sich gleichmäßig auf die Flächen verteilt. Dadurch verkantet sich der Magnet nicht beim Einpressen oder wird durch punktuelle Belastung zerbrochen.
Achtung! Damit die Magneten als Stapel aneinander haften können, wie auf dem Bild, muss die Ausrichtung der Pole gleich sein. Deshalb muss die Polrichtung vor dem Einpressen in das Gehäuse geprüft werden. Nachdem der Magnet eingepresst ist kann er nicht mehr entfernt werden ohne das Gehäuse zu zerstören.
