Fringe Case #3 - Yamaha YG450D Generator Choke Bushing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Yet another fringe case, one off product that no one may never have need for. This time we are replacing the choke rod…
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 12
- Makes
- 0
- Views
- 214
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Yet another fringe case, one off product that no one may never have need for. This time we are replacing the choke rod bushing on a Yamaha YG450D generator. The original is a rubber piece, so you might could print this in TPU or other flexible material. I just used PLA and it works fine. In addition to this piece, you will need an o-ring to hold the part in place. The o-ring I used is 4mm inside diameter by 1.45mm thick. Just put the bushing in place through the mounting plate, slide the o-ring up into the groove to hold it in place and run the choke rod through the bushing. Easy peasy.
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Supports:
No
Resolution:
0.2mm - 0.3mm
Infill:
40%
Category: Other