1 / 2
Fringe Case #3 - Yamaha YG450D Generator Choke Bushing — zdjęcie 1
1 / 2

Fringe Case #3 - Yamaha YG450D Generator Choke Bushing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Yet another fringe case, one off product that no one may never have need for. This time we are replacing the choke rod…

Ocena
0 / 5
Polubienia
5
Pobrania
12
Wydruki
0
Wyświetlenia
214
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Yet another fringe case, one off product that no one may never have need for. This time we are replacing the choke rod bushing on a Yamaha YG450D generator. The original is a rubber piece, so you might could print this in TPU or other flexible material. I just used PLA and it works fine. In addition to this piece, you will need an o-ring to hold the part in place. The o-ring I used is 4mm inside diameter by 1.45mm thick. Just put the bushing in place through the mounting plate, slide the o-ring up into the groove to hold it in place and run the choke rod through the bushing. Easy peasy.


Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Supports:

No

Resolution:

0.2mm - 0.3mm

Infill:

40%

Category: Other

Tagi