Nerf Blaster M16-Style Picatinny Carry Handle Sight
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
M16-style picatinny mount carry handle/ rear sight with elevation adjustment
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 47
- Makes
- 1
- Views
- 456
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
M16-style picatinny mount carry handle* / rear sight with elevation adjustment.
Hardware required:
1x M3 heat-set insert (4.5mm diameter x 6mm) for adjustment wheel
1x M3 x 25mm screw
2x M3 x 10mm screws (to stabilize sight when elevation is extended)
1x M3 nut
2x M4 x 30mm screws (ideally around 27mm, cut them down a bit if you want)
2x M4 nuts
Supports required for most parts
Print 2x each of block1 and block2, 100% solid for strength
Thread the 2 M3x10 screws directly into the outer holes in the top sight block. They should slide freely in the holes in the main body (but a bit of friction is good.) Screw in the M3x25mm screw and nut tightly. Insert the wheel with the threaded insert side up, and assemble.
Pick a peep sight aperture size and slot it in, glue if needed.
Works well with something like DuckyIndustries' Ducky Iron Sights front sight
I'll try to add windage adjustment some day
* Maybe not recommended to actually carry the blaster with!
:)