1 / 6
Nerf Blaster M16-Style Picatinny Carry Handle Sight — zdjęcie 1
1 / 6

Nerf Blaster M16-Style Picatinny Carry Handle Sight

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

M16-style picatinny mount carry handle/ rear sight with elevation adjustment

Ocena
5 / 5
Polubienia
26
Pobrania
47
Wydruki
1
Wyświetlenia
456
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

M16-style picatinny mount carry handle* / rear sight with elevation adjustment.

Hardware required:

1x M3 heat-set insert (4.5mm diameter x 6mm) for adjustment wheel

1x M3 x 25mm screw 

2x M3 x 10mm screws (to stabilize sight when elevation is extended)

1x M3 nut

2x M4 x 30mm screws (ideally around 27mm, cut them down a bit if you want)

2x M4 nuts

Supports required for most parts

Print 2x each of block1 and block2, 100% solid for strength

Thread the 2 M3x10 screws directly into the outer holes in the top sight block. They should slide freely in the holes in the main body (but a bit of friction is good.) Screw in the M3x25mm screw and nut tightly. Insert the wheel with the threaded insert side up, and assemble. 

Pick a peep sight aperture size and slot it in, glue if needed.

Works well with something like DuckyIndustries' Ducky Iron Sights front sight

I'll try to add windage adjustment some day

 * Maybe not recommended to actually carry the blaster with!

:)

Tagi