2.13" e-paper case for 18650 cell (LilyGo T5)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slightly angled tabletop case for a small e-paper in horizontal orientation.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 41
- Makes
- 1
- Views
- 269
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
This is a simple two-part case design for a LilyGo T5 2.13inch e-paper display. Specifically, the one I used here is a DEPG0213BN type from Aliexpress. That panel has direct support in ESPHome through model: 2.13inv3 and even supports partial updates.
The front part fits around the board very snugly and has four small pins matching the holes in the corners. I just glued mine in but you can also melt the plastic a bit to hold the display in place.
The back part is designed to hold either an 18650 cell with soldered / welded leads, or a flat pouch as you see in the pictures. It is angled to make it readable when standing on a table. I printed it on the cut-off rear edge, so the layer lines align with the front piece.
Fully designed in SolveSpace.