2.13" e-paper case for 18650 cell (LilyGo T5)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slightly angled tabletop case for a small e-paper in horizontal orientation.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 40
- Wydruki
- 1
- Wyświetlenia
- 265
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple two-part case design for a LilyGo T5 2.13inch e-paper display. Specifically, the one I used here is a DEPG0213BN type from Aliexpress. That panel has direct support in ESPHome through model: 2.13inv3 and even supports partial updates.
The front part fits around the board very snugly and has four small pins matching the holes in the corners. I just glued mine in but you can also melt the plastic a bit to hold the display in place.
The back part is designed to hold either an 18650 cell with soldered / welded leads, or a flat pouch as you see in the pictures. It is angled to make it readable when standing on a table. I printed it on the cut-off rear edge, so the layer lines align with the front piece.
Fully designed in SolveSpace.