Fishing Pole Garage Door Hanger - REV2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed my original model to provide more clearance between rods using spinning reels.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 107
- Makes
- 0
- Views
- 501
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial
Introducing REV2 of my fishing rod holders
Over time we have acquired more spinning reels, the original design did not have enough clearance for those so REV2 was made. I recommend you put the heaviest rod on the bottom for better swing actuation.
Large size model is under 300mm so you can use a wide brim on a larger printer; Medium is 252mm long so it will fit on standard sized printers with a small brim. These print best when aligned in Y direction with my SV08 toolhead, but if you need the larger size and have a standard sized printer you can rotate the print to be diagonal on your bed.
I recommend using PETG, 3 layers, 20% gyroid infill. I am using a 0.6mm nozzle to make these on my SV08, it gives them more strength with larger layer height and increased wall thickness.