AD5M/ Adventurer 5M Top Mounted Spool Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
READ FULL DESCRIPTION
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 46
- Makes
- 0
- Views
- 350
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The arm should be printed in the orientation provided with support for the 15mm-cable chain horn if applicable. The tolerance for the ½ inch PVC hole is 0.1mm and may have to be sanded if printed without proper calibration. I used approximately 220mm of PVC for the horizontal arm.
This model will also work with just one of the arms, cut the PVC shorter but leave some still hanging out the empty side for better grip.
The TUBE roller bit fits over top of the BEARING roller bit with a tolerance of 0.1mm so again scale to your calibration needs or sand if needed. The bearings both have an internal tolerance of 0.4mm. they should be tight enough to move but not loose enough that they spin continuously
I suggest playing with scarf seams to get a nice smooth surface all the around the bearings. I wasn't able to get it 100% clean and regular aligned seam is still okay, scarf will produce better results though if calibrated.
Have suggestions or specific use cases you think this could be adapted to? Let me know and I'll try to accommodate or provide you additional files. Thank you!
this is a repost check it out here- https://makerworld.com/en/models/528137-ad5m-dual-spool-roller-printed-bearings-pvc-insert?from=search#profileId-446493