2.5 kg Anti-Overspin Spool Holder – No Bearings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple 2.5 kg spool holder for RS300/15GZ spools, designed to reduce filament unwinding during long retraction.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 72
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Why no bearings?
For years, we tried to use spool holders and rollers with the lowest possible friction. The idea was simple: the spool should rotate as freely as possible so the filament does not create unnecessary resistance for the extruder.
However, after switching to the Prusa XL, this became a problem.
Because the Prusa XL has a large build area and the toolhead can move very quickly from one side of the print to the other, bearing-based rollers allowed the spool to keep spinning due to inertia. During long retractions or fast movements, the spool could rotate too much and the filament could unwind from the spool.

This holder intentionally does not use bearings. The slightly higher friction helps prevent the spool from overspinning and significantly reduces filament unwinding.
Compatibility
Designed for 2.5 kg RS300/15GZ spools (offered eg. by Fillamentum).

Print instructions
Size
The holder is 298 mm long, so it fits on 300 mm print beds.
Overall height: 167 mm (base without rod)
Material
PLA works perfectly fine for this model.
One holder uses approximately 100 g of filament, depending on slicer settings.
Recommended settings
Layer height: standard profile is fine
Perimeters: 3
Infill: 15 %
Supports: not needed
Brim: not needed
Notes
This design does not completely eliminate the possibility of filament unwinding, especially with new full spools or poorly wound filament. However, in our experience, the issue was reduced significantly compared to bearing-based spool rollers.
The model is simple, lightweight, easy to print, and does not require any additional hardware.