1 / 4
Fence post mount 40x60 - Blink Outdoor - Zaunpfosten — image 1
1 / 4

Fence post mount 40x60 - Blink Outdoor - Zaunpfosten

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

EN: Mounting bracket for Blink Outdoor for 40x60mm fence posts. DE: Befestigung für Blink Outdoor an 40x60mm Zaunpfosten

Rating
0 / 5
Likes
3
Downloads
15
Makes
0
Views
113
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

*** german below ***

EN:
Needed to mount a Blink Outdoor camera to a 40x60mm fence post. As I didn't want to damage the post by drilling into it, I made this bracket.

Its printed narrower on the open side, so It snaps nicely into place with tension. It can be secured with double-sided tape or anti slip material. Not neccessary in my case.

Camera gets screwed with original stock screws to the circular adapter plate and to the bracket.

This was my first print using eSUN's ASA+. The print is not perfect but acceptable. Let's see how it holds up to the weather and the sun.

Print settings

  • for outdoor use, don't use PLA. I used ASA+ by eSUN

  • 0,3mm layer height, 260° nozzle, 110° bed, on a Neptune 4 Pro

  • I adjusted the speed to 50 mm/s for walls and 100mm/s for infill

  • 3 walls, 4 top/bottom layers

  • Infill Gyroid 10%

  • I added modifiers around the holes with 100% infill so the screws have something to bite into

DE:
Ich musste eine Blink Outdoor Kamera an einem 40x60mm Zaunpfosten befestigen. Da ich den Pfosten nicht anbohren wollte, habe ich diese Halteklammer gemacht.

Die Klammer-Enden sind entwas nach innen zulaufend gedruckt, durch die Vorspannung halten sie schön am Pfosten und schnappen ein. Hält gut. Bei Bedarf kann man mit doppelseitigem Klebeband oder Moosgummi gegen verrutschen sichern. Bei mir war das allerdings nich notwendig.

Die Kamera wird mit den Originalschrauben durch die runde Adapterplatte und die Halteklammer geschraubt.

Dies war mein erster Druck mit eSUN ASA+. Der Druck kam nicht perfekt aus dem Drucker, aber akzeptabel.

Druckeinstellungen:

  • Bei Verwendung außen, verwendet kein PLA! Ich habe eSUN ASA+ verwendet

  • 0,3mm Schichthöhe, 260° Düse, 110° Platte, Neptune 4 Pro

  • Musste die Geschwindigkeit auf 50 mm/s für Wände und 100mm/s für Infill anpassen

  • 3 Wände, 4 Schichten oben und unten

  • Infill Gyroid 10%

  • Um die Löcher habe ich Modifizierer hinzugefügt und dort 100% Füllung eingestellt, damit die Schrauben was zu beißen haben

Tags