iPad (7th) VESA Mount and Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A latching VESA mounted stand for the iPad (7th gen, 10.2")
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 90
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- GNU General Public License v3.0
Changelog:
5/12/26 - Base has been updated to be a hollow shell, and the VESA Hinge has some added ribbing
A VESA mounted bracket and stand for an iPad 7th gen tablet. The iPad latches into place with an over center latch and the bracket mounts to any standard 75mm x 75mm VESA plate, but I also made a small folding stand to go with it.
Printing Notes
The Bracket Body should be printed on its side with supports. A thick brim (~20mm) should hold it down and prevent warping .
The Stand Base would has a large bottom surface area that would probably benefit from a brim if you can fit it, but it takes up most of the build volume on my MK3S+.
BOM
(HSHC - Hex Socket Head Cap, HSFHC - Hex Socket Flat Head Countersunk)
Bracket:
4x M3 x 12mm HSHC Screws
2x M3 x 20mm HSHC Screws
4x M4 Heat Set Insert
4x M4 x 10mm - 15mm screws (for mounting)
Stand
2x 3/8"-16 x 1.5" Bolt
2x 3/8"-16 Nuts
4x M3 x 18mm HSFHC Screws