Small IEM Eartip/Tip Case

Made these as a smaller piece to compliment the larger case made by @lw_1c922_1431804.

I want to say it's inspired by the DUNU case, but it's straight up a recreation, although I did include a few other variants. In terms of size, it's slightly shorter and more square to give the tips at the edge more space.

3.5 variants each of the pegs on a single face and the pegs split on both faces, these variants include:

• Separate lid and bottom

• Print in place hinge

• Living hinge

  • 0.2mm layer height

  • 0.08mm layer height

  • Do I recommend printing one over the other? I don't know, haven't done enough testing

All printed in PLA, half using variable layer height and the other half at 0.2mm. PETG would probably be more resilient for the living edge but haven't tried that yet. These are only about 16g so give them a shot.

Tip for strengthening living hinges: Add a modifier, use monotonic top surface pattern for just the hinge section, do this if you're using concentric for rest of body like I did.

Update #1 (26.05.25): Added a missing chamfer to a few models

Update #2 (26.07.17): Added smaller living hinge, and a new case which includes a cutout for the few people with Snowsky Tinys