ScreenBall - Parametric dodecahedron with mesh screen faces
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A parameteric dodecahedron, individually printable facets, with grooves to install window screen mesh for the faces.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Share Alike
I'm not really sure what the purpose of this is. I replaced the screens in some of the windows and wanted to do something with the old screens, so I made this. It's a dodecahedron with individually printable facets. There are grooves to install mesh screen on each facet, and the facets connect together by using a piece of 1.75 filament for hinges. Maybe you can come up with a reason for its existence.
You can make adjustments to the Onshape model. Adjust the size in the top-left 'Configurations' panel, then right-click on a facet in the 3D view and 'Export'. You need to export the normal piece and the separated 'snap in' piece.
Assembly Instructions:
Screen Installation:
I used
To size the screen, use the printed facet like a cookie cutter: place the facet against the screen and used the exacto knife to trace the facet out of the screen.
placed the screen over the grooved side of the facet, press the screen into the groove using the spline, along one side of the facet and then use the concave roller to push it in. The grooves extend straight through the entire facet to make rolling easy.
repeat for all 5 sides. Once all 5 sides are initially pressed in go over it again with the 'toothed' tool (or just press in with a butter knife).
Trim any excess screen
Assembly:
I used:
Needle nose pliers
The facet hinges easily fit together, then are secured with a piece of 1.75mm filament.
This is very easy at first, but the more facets that are connected the less room there is to work with.
I found that pre-cutting about 30mm of filament, gripping it with needle nose pliers, then slide it through the hinges 'from the inside'. ie, start in between the hinges, press the filament through the left-side hinge until it has passed through enough that end of the filament can fit in the right-side hinge, and then slide it back.