Mason Jar Funnel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A funnel with a small handle designed for a mason jar.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 60
- Makes
- 0
- Views
- 188
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Summary
I did not like the slope and surface quality of existing funnel designs, so I set out to create my own. The goal was to minimize the need for supports while delivering a smooth, clean finish.
Example Print Settings
Material: Polymaker Pancharoma PLA
Nozzle: 0.4mm @ 220°C
Bed: PEI @ 62°C
Layer Height: 0.2mm
Max Volumetric Speed/Flow: 12mm³/s
Infill: None (walls are too thin and will print solid automatically)
Brim: In and Out, 10mm
Supports: Tree/Organic, handle area only
Note: The included G-Code file uses Prusa PLA defaults and does not reflect my exact print settings. While the two are very similar, my actual settings were fine-tuned through extensive calibration specific to my MK3.5S.
Thank you for visiting my page! If you find this funnel useful and it prints well for you, please consider leaving a like and a rating!
Products
Disclaimer:
Links may take you to Amazon or Prusa.com for products I endorse and use on a regular basis.
JD3D is not responsible for any damage or harm caused by improper production, assembly and use.