Elgeoo Neptune acceleration sensor mountings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
X and Y mountings for acceleration sensor on Elegoo Neptune series printers.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I used an MPU-6050 sensor, but others may work if the meet hole spacing described below.
Only tested on Neptune 3 Pro, but it could work on other printers with the same tool head.
Additional parts required:
Acceleration sensor with mounting holes distanced by 15 mm
5x (minimum 4x) M3 x 4 to 7 mm
7x M3 heat brass inserts with an outer insertion diameter of 4.3 mm
2x washers (facultative)
You should also verify that you bed holes are distanced by 91 mm.
Don't hesitate to contact me if you need a modified version, or the FreeCAD project file!
Check out my blog post on my tuned Neptune 3 Pro: https://github.com/zetiti10/display_connector