1 / 8
Ender 3 s1 /s1 Pro /s1 Plus. Dual Filament sensor holder — image 1
1 / 8

Ender 3 s1 /s1 Pro /s1 Plus. Dual Filament sensor holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sentered sensor mount, using the existing screw holes. Quick, sturdy and very easy to print.

Rating
0 / 5
Likes
0
Downloads
3
Makes
0
Views
58
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I did not find a sentered sensor that I liked so I made one that was easy to print, sturdy and prints without support.

Optimized for 0.2mm layer hight.
15% infill 
One wall top layer.
No support needed!!


Using the existing M3 threaded inserts in the filament holder bracket.

You need three M3x10mm screws and two M3 nuts. 

1. Take the rear screw off.
2. Reuse the metal spacer and tighten the new screw and the first M3 nut to the spacer still in place.
3.. This will still turn freely so you can fasten it to the print with the second nut as shown in the pictures.

The two holes on the bottom is to rest the filament when not in use.

And again. No need for support.

Tags