WS9290 Blower and Controller Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
WS9290 Blower and Controller Mount
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 10
- Makes
- 0
- Views
- 172
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
WS9290 Rear Panel Blower Mount
A simple, rigid mount for securing the WS9290 blower flush against your printer's rear panel. Designed to keep your CPAP hose connection as short as possible by mounting at the top of the back panel. Includes integrated mounting points for the motor controller via heat-set inserts.
Note: This mount does not act as a muffler.
Print Settings 5 Top/Bottom Layers 3 Walls 20% Infill
ABS is strongly recommended. The WS9290 generates heat at the motor housing and blower outlet — PLA and PETG may deform over time.
Hardware:
M3 heat-set inserts x4
M3×6mm screws x4
M3×12mm screws x2
M4×12mm screws x4
M5×12mm screws x3
19mm CPAP hose x1
Ws9290 Blower x1
Link to ws9290 CPAP Blower: https://excit3d.shop/shop/wonsmart-ws9290
Assembly
Press the rubber fitting into the CPAP pass-through hole in your rear panel and seat the WS9290 nozzle into the fitting.
Position the mount and fasten it to the panel.
Attach the WS9290 blower to the mount.
Press the heat-set inserts into the mount and secure the motor controller with M3×12mm screws.
Connect the power and PWM wires to the motor controller.