Presupported High County Blasters MPP Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Its the long shroud, but I added some towers on the side to prevent it from spaghettying.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 11
- Makes
- 0
- Views
- 215
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
The original model had basically no surface area on the one flat surface where no excessive supports would be necessary, so I added some sacrificial towers connecting to the model with some sprues to help prevent it from turning into spaghetti. Removing the towers should be pretty easy, you may want to clean up the small blemishes with snips or an exacto knife or similar. Brims should be unnecessary, but I was paranoid and gave it one anyway. Not preoriented, but if you can't tell which side to print on, I don't know how to make it more obvious.
The 0.X corresponds to the layer height you are using, so if you are using a 0.3 layer height, use the 0.3 option. The sprues should be exactly one layer height in thickness for easy removal.
Steps for remixing the towers should you need to.