DFRobot Beetle ESP32-C6 - ZigBee scene switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3x ZigBee button to which you can assign different tasks according to your code
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 35
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
This is another case designed for the DFRobot Beetle ESP32-C6.
It is prepared for 12x12 7.5mm tact switches. If you prefer the button caps to be more protruding or the opposite, you can choose a different size instead of 7.5mm according to your preference. Since gluing the buttons caused various issues, I created a support piece on the back. If you apply glue to the protrusions where this piece fits into the main body and secure it in place, you won't experience any problems. Another advantage is that if you ever need to disassemble it, simply removing the support piece will suffice. The Beetle has its own voltage divider, and if you select the LP (low power) GPIO pins for the three buttons, you won't need to use additional pull-up resistors for them either. This way, you can achieve a clean setup with only 4 wires: a common GND for the buttons and one wire from each of the three buttons
Additionally, you will see small oval recesses on the bottom cover of the button housing and on the wall mount bracket. I left these for magnets, because I have this type of magnets. The magnets I use are D5x1mm in size. They don't hold incredibly firmly, but they do their job more than adequately