Umbilical Cord CPAP + CAN + PTFE Clamp/Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A CPAP hose clip to gather your CAN and PTFE tube in one neat cord
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 29
- Makes
- 0
- Views
- 114
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I went looking for a clip that could hold my CAN bus cable, PTFE tube, and CPAP hose together as a tidy umbilical for my Ender 5 / Mercury One.1 build. Inspired by an existing design, I decided to make my own.
Three sizes are available, each slightly tighter than the last. Depending on how snug a fit you need, how careful you're willing to be, and how much struggle you can tolerate, I generally recommend the largest.
Tight (100%)
For those with a slimmer CAN bus cable. The PTFE tube snaps in with a satisfying click, but fitting the 15 mm CPAP hose can be a challenge.
Standard (101%)
A tight fit for the CAN bus cable that ships with the BigTreeTech EBB toolhead boards. I use this size on my printers that run above 500 mm/s.
Loose (103%)
Easier to work around the 15 mm CPAP hose, with a slightly looser fit on the BTT CAN bus cable, but it still holds well. I use this on my Voron 2.4 with a heated chamber, and I've added a strip of tesa loom tape inside the clip to help it grip.
Print one in the size you think will suit you best before committing to a full set. You can try 105% if you have larger-diameter cables or want an even looser fit — just be aware this can grind against the hose on faster machines.
Print settings
4 walls
0.2 mm first layer
0.1 mm layer height
No brim
PETG (or ASA for heated chambers)
Avoid stiff, hard materials — they'll make installation miserable.
I print enough clips to space them roughly every 10 cm along the umbilical.
I recommend slowing the first layer to about 50% of your normal speed. The toolpaths on these are a little awkward and prints can come loose; a spritz of 3DLAC adhesion spray should do the trick.
Installation
⚠ Be very careful not to puncture the hose when wrapping the clip around it.
Start with the CPAP hose. Grip both ends of the clip and bend them outward slightly (if you bend to hard you risk deforming it beyond its elastic limit). while laying it perpendicular to the hose, then wrap it on with a twisting motion. Take care not to poke the hose with the clip's tips. This is much easier with the loose version and nearly impossible with the tight one.
Fit the CAN bus cable next.
Fit the PTFE tube last — but don't fit it to the clip closest to the toolhead, as this can cause trouble.
Mind the orientation so the PTFE tube and CAN bus cable don't end up crisscrossing.