Mini Super Glue Keychain Holder

Mini Super Glue Keychain Holder

Keep a tube of super glue with you at all times.

This compact keychain case is designed specifically for the Loctite Super Glue Mini Trio tube, giving you a clean and secure way to carry it on your keys, backpack, or EDC setup. The tube was first modeled precisely, then the case was designed around it with carefully tuned tolerances to ensure a snug fit while still being easy to remove and use. Even after piercing/opening the glue tube by twisting the cap for first use, it still fits perfectly inside the holder.

Features

• Designed for Loctite Super Glue Mini Trio

• Compact EDC/keychain-friendly design

• Magnetic closing system using 6x1.5 mm magnets

• No supports required

• Smooth surface finish with 0.08 mm layer height

• Secure fit with optimized offsets and tolerances

• Easy access to the glue tube

• Clean sliding lid design

Print Settings

• Material: PLA

• Layer Height: 0.08 mm

• Supports: Not required

• Important Slicer Pauses: Add a pause command at layer 25 and layer 142 to embed the magnets during the print.

Assembly

1. Pause at Layer 25 & 142: When the printer pauses, place a tiny drop of glue into the designated magnet slots.

2. Insert Magnets: Insert the 6x1.5 mm magnets into the slots.

3. Check Polarity: Make sure to keep the polarization in the same direction so that the magnets attract each other once the case is assembled.

Notes

This model was designed with real-world usability in mind:

• The glue tube fits tightly without rattling.

• The lid stays secure thanks to the embedded magnets.

• The opened tube still fits correctly after first use.

A practical little accessory for makers, repair kits, workshops, and everyday carry setups.