Core One L hepa-carbon filtration unit.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Magnetic mounted filter box utilizing vacuum hepa filters, carbon pellets, and two 40mm 24 volt fans.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
Parts needed:
Mini vacuum hepa filters https://www.amazon.com/dp/B0FWGYBH91?ref=ppx_yo2ov_dt_b_fed_asin_title
Neutral PH carbon media
Two 40mm 24 volt fans.
Two 10x2 magnets.
Wire, shrink tube, solder
Directions:
Print both parts out of PETG or a material with greater temperature resistance (asa/abs/etc)
Snap fans in.
Guide fan wires through the hole for routing, I ended up using a piece of solid core bell wire and tape as a cable snake.
Terminate wires accordingly. I used a Noctua extension cable for the connectors so the filter box can be disconnected for service.
Fill media shelf with activated carbon, I ended up overloading it a bit and shook some of the pellets up into the hepa filters.
Glue in two 10x2mm magnets.
Install in back left corner.