Meross MSG100 Extended Magnet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A collection extended magnets for the Meross MSG100 smart garage door opener.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Standard Digital File License
Sometimes, positioning the sensors for your Meross MSG100 is difficult. In my case, the magnet was too far from the reed switch. This led to the system thinking the door was always open. I didn't want to mess around with brackets, so I made this replacement for the included magnet:
Comes in multiple lengths, so you can cater it to your situation: 55mm, 50mm, 45mm, 40mm, 35mm, 30mm
Designed for 10x3mm magnets
Comes with built-in supports. Twist and pull with needle nose pliers to remove
Dimples provide extra grip for you N52 lovers
0.2mm layers in PETG recommended
Tips:
Magnets are press fit, so you shouldn't need glue. If you decide to remove them, insert a 3mm hex key into the holes on the opposite side and push
If you're unsure of what length you need, stack magnets near the reed switch until the door is detected as closed. Remove the magnet stack, measure, and choose the closest sized extender. Meross recommends a 1"/25mm gap between the magnet and reed switch, although this is with the stock setup, so you may need to experiment