1 / 2
Segway Ninebot Max G3 Mount for New York Fahgettaboudit Mini Lock — image 1
1 / 2

Segway Ninebot Max G3 Mount for New York Fahgettaboudit Mini Lock

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mounts the Kryptonite New York Fahgettaboudit Mini securely onto the neck of the Segway Ninebot Max G3.

Rating
5 / 5
Likes
5
Downloads
33
Makes
2
Views
352
Reviews
2

Updated at source:

Model information

License
GNU General Public License v3.0

Version 2

Version 2 is designed so that you don't need to remove the key and reinsert to remove from the holder. It has less plastic and empirically has less plastic and therefore potentially less rigidity, but in my experience it has been just as sturdy. Compare them yourself and see which one is right for you.

Introduction

The Segway Max G3 comes with mounting points for a supplimentary battery, but with that not being available in my region I decided to repurpose the mounting screws to hold my Kryptonite New York Fahgettaboudit Mini lock. If this isn't your exact lock, please check out the remixes of this model as there is at least one (at the time of writing) remix to fit another lock type!

Features

  • Designed for printing at maximum strength.

  • Contoured to the curve of the mounting area.

  • Difficult (not vandal proof) to remove the lock without unlocking it.

  • Hole closing optimisations for optimal printing of all holes.

  • Contoured mounting surface matches the curvature of the neck.

  • Re-uses the existing M6 bolts supplied with and already installed on the scooter.

  • Leaves the turbo-charging port free for use, but precludes installation of external battery.

Vitamins

  • None! Uses the existing M6 bolts that are already supplied installed in-place on the Max G3.

  • The M6 bolts supplied installed on the scooter have 16mm of thread.

  • Design uses 8mm of thread leaving the other 8mm for good purchase on the scooter bolt holes.

Printing

  • Recommended to print as oriented in the STL i.e. lying on the right side for strength.

  • This part will be subject to a lot of stress!

  • Bring your best functional printing game!

  • My settings for ABS were:

    • 0.25mm layer height (0.5mm nozzle)

    • 7 perimeters (vertical shells) with 0.6mm internal and 0.7mm external perimeters

    • 4 top layers

    • 5 bottom layers

    • 20% rectilinear infill at 0.8mm width

  • Supports:

    • Are needed on the connecting spar that's not on the build surface

    • Three test prints suggest no other supports are needed on the model.

Remixing

  • Designed in Fusion 360 a.k.a Autodesk Fusion.

  • F3D file attached, with parameters for easy editing if you have a similarly sized lock.

  • Please note copyleft license for derivative works.

  • Key measurements:

    • 193mm between the centre of the M6 mounting bolts.

    • Neck diameter of curvature is about 100mm (for a good-enough fit of this part).

    • All measurements available in the F3D file as parameters.

  • I had designed it to also print in two parts but didn't get around to it. That said it should be easy enough to split the parts to print seperately and without the connecting spars.

    • If you do, please post a remix on this site!

References

Tags