1 / 1
Barrina T5 Clip for IKEA SKADIS LED light bar holder — image 1

Barrina T5 Clip for IKEA SKADIS LED light bar holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of mistic100's SKADIS LED light bar clip, resized to fit a Barrina T5 LED bar. Pins to the same SKADIS arm.

Rating
0 / 5
Likes
1
Downloads
16
Makes
2
Views
80
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

Barrina Clip for IKEA SKÅDIS LED light bar holder

A remix of mistic100's IKEA SKÅDIS LED light bar holder, with the clip resized to fit a Barrina T5 LED light bar (~20.5 × 20.5 mm cross-section). The mounting interface is unchanged, so this clip pins to the same SKÅDIS arm from the original project — you can mix this in alongside the author's existing clip variants.

Recommended print settings

  • Orientation: flat bottom on the build plate (no rotation needed)

  • Supports: none required

  • Layer height: 0.2 mm

  • Infill: 20–30 %

  • Walls: 3+ perimeters (the prongs need to flex a bit when the bar snaps in)

  • Material: PLA or PETG both fine

Assembly

  1. Print the clip.

  2. Slide the LED bar in from the front opening — the bar snaps past the two retention lips and seats in the wider region behind them.

  3. Attach the clip to the SKÅDIS arm with an M3 screw through the counterbored hole (same hardware as the original).

Credits & license

Original design by mistic100 — Ikea SKÅDIS LED light bar holder. Licensed CC BY-SA 4.0; this remix is shared under the same license.

Tags