1 / 1
Easy Low Filament Bridge Calibration — image 1

Easy Low Filament Bridge Calibration

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

When printing expensive filaments (looking at you polycarbonate), use this to calibrate bridging with low filament usage

Rating
0 / 5
Likes
6
Downloads
93
Makes
0
Views
408
Reviews
0

Updated at source:

Model information

Category
Test Models
License
Creative Commons — Attribution

IMPORTANT: set the  external bridge infill direction to 90 degrees. This setting can be found under Strength>Advanced in orcaslicer. 

How to get good results

  1. make six of these calibration thingies, and change the bridge speed for each one. For engineering materials, I like to start at 10mm/s, and add 10mm/s to each one. Save results

  2. erase all the settings for every test piece, and turn on the Thick External Bridges setting. For the first piece, set the bridge density to 100%, and add 5% for each one. Save results. 

  3. profit

Tested in orcaslicer 2.4.0 Alpha with Polymaker Polymax PC

Tags