1 / 1
Easy Low Filament Bridge Calibration — zdjęcie 1

Easy Low Filament Bridge Calibration

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

When printing expensive filaments (looking at you polycarbonate), use this to calibrate bridging with low filament usage

Ocena
0 / 5
Polubienia
6
Pobrania
93
Wydruki
0
Wyświetlenia
408
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution

IMPORTANT: set the  external bridge infill direction to 90 degrees. This setting can be found under Strength>Advanced in orcaslicer. 

How to get good results

  1. make six of these calibration thingies, and change the bridge speed for each one. For engineering materials, I like to start at 10mm/s, and add 10mm/s to each one. Save results

  2. erase all the settings for every test piece, and turn on the Thick External Bridges setting. For the first piece, set the bridge density to 100%, and add 5% for each one. Save results. 

  3. profit

Tested in orcaslicer 2.4.0 Alpha with Polymaker Polymax PC

Tagi