AtomRC Swordfish Walksnail VTX Pan Mount

Take your FPV experience to the next level with this custom-designed mount for the ATOMRC Swordfish. This all-in-one mounting solution is specifically engineered to cleanly integrate a Walksnail Avatar digital VTX, the FPV camera, and dual antennas into a single assembly with a pan servo.

Key Features

• Integrated Pan Mechanism: Features a integrated low profile servo mounting point, allowing the entire camera to pan side-to-side for an immersive, wide-angle view of your flight.

• Dedicated Walksnail VTX Plate: The main deck includes a standard 4-hole mounting pattern tailored to securely fasten your Walksnail VTX board, ensuring adequate airflow and stability.

• Optimal V Antenna Routing: Includes dual rear cylindrical tubes angled in a precise "V" configuration. This keeps your Walksnail antennas perfectly separated for maximum signal reception while preventing them from snagging or bending during flight.

• Drop-In Swordfish Fit: Designed with a bottom alignment tab to slot perfectly into the ATOMRC Swordfish fuselage/canopy setup.

Recommended Print Settings

• Material: PETG, ABS, or ABS-like resin (PLA is not recommended due to the heat generated by the VTX and potential exposure to sunlight).

• Infill: 25% - 30% (Gyroid or Cubic for optimal strength-to-weight ratio).

• Perimeters: 3 to 4 walls for added durability around the servo spline and mounting holes.

• Supports: Standard supports recommended for the camera box overhangs and the antenna tubes.

Required Hardware

• 1x Micro Pan Servo (standard 9g or similar, depending on your setup)

• Screws for the VTX board (typically M2)

• Screws for the FPV camera