1 / 5
ZK-1001u Amp case with latching lid and gasket — image 1
1 / 5

ZK-1001u Amp case with latching lid and gasket

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

ZK-1001u Amp case with latching lid for use in speaker boxes.

Rating
0 / 5
Likes
19
Downloads
138
Makes
0
Views
1,047
Reviews
0

Updated at source:

Model information

Category
Audio
License
Creative Commons — Attribution — Noncommercial — Share Alike

About please read

All of my files are free however I spend lots of time on the designs. If you would like to make a donation/tip to show your appreciation it is welcome.  https://www.venmo.com/u/Bradley-Valentine-6

I also welcome constructive input on the designs for future editions. 

ZK1001 amp case bom

Hardware

6-m4 X 20MM button head bolts       (hinges, latches, and post for overcenter latch)

6-m4 nuts

2-m3 x 8mm button head bolts         (mounts amp in case)

4-m3 x 16mm button head bolts       (mounts case to box)

6-m3 nuts

 

Prints

PETG

1- ZK-1001u amp case

          Print face down with supports painted on the face the amp mounts to inside the case. Use adaptive layer height, quality/speed 0.35, radius 4, click adaptive once and then smooth twice.

1- ZK-1001u lid

          Print with top lid down. Use adaptive layer height, quality/speed 0.35, radius 4, click adaptive once and then smooth twice.

1- Bracket

          Print with hex holes facing up

2- Latches

          Print on side

 

TPU

(I used 85a shore hardness I would have liked to use something softer but this is what I had and it worked out pretty good.)

1- Gasket

          One side is flat and one is curved with the middle of the gasket being thinner than the outer edges.          Flat side should face the build plate.

 

Instructions

Install 2 m4x20 and nuts into the lid in the holes shown below. These will not attach anything to the lid and will only be used as the post for the over-center latch to grab

Next install the latches as shown below. Use 2 m4x20 blots and nuts to hold them. do not overtighten as the latches can get hard to move if you do so.

Next install the lid on the case using 2 m4x20 bolts and nuts in the orientation shown below.

Next the gasket will press into the slot in the lid. The gasket has a slight curve to one side to compensate for warpage of the petg. Make sure when you print to orient this side up. Place the curved top side of the print into the lid first so the flat side will face the case.

 

Next use the m3x8 screws and nuts to screw the faceplate of the amp to the case. Make sure you have attached wires before doing this step as once it is in the case you will not be able to access the screw down posts.

 

Next cut out your hole using the bracket as a template.

Apply sealant of your choice to bot sides of the box and slide the amp into place.

Slide the bracket with the nuts already pressed into place over the amp case on the inside of the box and use the remaining 4 m3x16 bolts to secure the case into your box.

Tags