Thick Laptop Stand (3/4" - 19.05mm)

Summary

This stand was designed to elevate my Alienware laptop, improving airflow and reducing heat buildup. While I loved the original design, it was not large enough to accommodate this particular laptop, so I created this modified version to ensure a proper fit.

Features

• Fits 3/4" (19mm) thick laptop. (May fit up to 1" but I have not tested)

• Multiple angle adjustment

• Raises the laptop off the table for better cooling

• Can use 2 or more to support the heavier laptops

Note: As shown in the photos, some flex is noticeable under the weight of the Alienware laptop. This can likely be resolved by increasing the infill to 100% or by adding an additional stand in the center for extra support. For most use cases, the current rigidity is sufficient.

Example Print

• Material: Polymaker PLA Pro

• Hard Nozzle: 0.4mm @ 240°C

• Bed: Prusa PEI @ 60°C

• Chamber Temp: 30°C

• Layer Height: 0.2mm

• Max Volumetric Speed/Flow: 35mm³/s

• Infill: Default 20% Cubic

• Walls: 4 to ensure edge strength

• Top & Bottom Layer: 10 (to strenghten)

• Brim/Skirt: 5mm outward

Note: I tested how fast I could print these and managed to hit around 350mm/s and there's probably still more speed to be had!

Thank You

Thank you for taking the time to visit my page. If you enjoy my design and prints, please consider liking, downloading, and saving to your favorites.  Constructive feedback is always welcome, it's the best way for me to continue improving!

Products

• CoreOne+

• CoreOne+ Ultimate

• MK4

• Polymaker PLA Pro

• Polymaker PolyDryer Box

Disclaimer:

• Links may take you to Amazon or Prusa.com for products I endorse and use on a regular basis.

• JD3D is not responsible for any damage or harm caused by improper production, assembly and use