Another MagSafe Phone stand/charger made to use inexpensive Amazon charging units.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MagSafe Phone stand/charger that uses inexpensive Amazon charging units, and metal brackets for weight.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 21
- Makes
- 1
- Views
- 112
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I was searching for a phone holder/wireless charger, but so many of them don't hide the USB plug and cable. I made this one to hide as much of it is possible. I have an older Android Note10+ phone without MagSafe, but my friends have iPhones, and it works with them.. This works with my phone, and should with MagSafe Phones. I made it to use these inexpensive Amazon charging units.
MagSafe two pack - https://www.amazon.com/dp/B0DLP157QH?
I weighted it with these metal brackets from Amazon.
Weight Plates - https://www.amazon.com/Straight-Brackets-Stainless-Mending-Joining/dp/B0BJYXGZ8J/
I've included 3 versions in the .stl and .step files. The flat surface at the front is good for adding text as shown in the image.
I printed these with only tree supports for the top arc of the charging disc opening.
To assemble, I slid the USB-C plug into the cable hole up to the disc opening, then slotted the disk partially on the plug and push it into the opening. (It is friction fit) I then used a screwdriver from below to push the USB plug all the way in. Following that, I added the weights, and installed the bottom cover with M3*10mm screws.