1 / 2
Another MagSafe Phone stand/charger made to use inexpensive Amazon charging units. — zdjęcie 1
1 / 2

Another MagSafe Phone stand/charger made to use inexpensive Amazon charging units.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MagSafe Phone stand/charger that uses inexpensive Amazon charging units, and metal brackets for weight.

Ocena
5 / 5
Polubienia
5
Pobrania
21
Wydruki
1
Wyświetlenia
115
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was searching for a phone holder/wireless charger, but so many of them don't hide the USB plug and cable. I made this one to hide as much of it is possible. I have an older Android Note10+ phone without MagSafe, but my friends have iPhones, and it works with them.. This works with my phone, and should with MagSafe Phones.  I made it to use these inexpensive Amazon charging units.

MagSafe two pack - https://www.amazon.com/dp/B0DLP157QH?

I weighted it with these metal brackets from Amazon.

Weight Plates - https://www.amazon.com/Straight-Brackets-Stainless-Mending-Joining/dp/B0BJYXGZ8J/

I've included 3 versions in the .stl and .step files. The flat surface at the front is good for adding text as shown in the image.

I printed these with only tree supports for the top arc of the charging disc opening.

To assemble, I slid the USB-C plug into the cable hole up to the disc opening, then slotted the disk partially on the plug and push it into the opening. (It is friction fit) I then used a screwdriver from below to push the USB plug all the way in. Following that, I added the weights, and installed the bottom cover with M3*10mm screws.

Tagi