EN Conduit Spreader Tool - Sizes M16 to M40
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tool to widen EN conduit so another pipe can be connected by press-fitting it into the widened section.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 14
- Makes
- 0
- Views
- 66
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Purpose
This tool is meant to widen the ends of EN conduit pipes. This allows for a press-fit connection to another pipe by simply sliding them into one another.
Sizes
Supported EN conduit sizes are:
M16
M20
M25
M32
M40
Assembly
The tool is designed to press-fit together. If desired, glue can permanently bond the two halfs together.
Usage
Take a heat gun and heat about 40 cm from the conduit's end inwards.
Heat it until it is almost too hot to touch or gets visibly soft.
Take the spreader tool and press it in. Rotating it might help the process.
In case it does not go in all the way at once, leave it stuck. Take the heat gun and reheat the conduit. Then continue pressing/rotating the tool in.
Note: The gcode information in the header is for the size M16 and is utilizing PrusaSlicer's "structural" print profile.