Various small sensor enclosures for use with fischertechnik
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Various sensor enclosures with grooves in the bottom that are compatible with the fischertechnik construction system
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The small 30x30x15mm enclosures are designed for:
-- Adafruit BME688 - Temperature, Humidity, Pressure, and Gas Sensor
-- Adafruit BME680 board - Temperature, Humidity, Pressure, and Air Quality Sensor
-- GY-9960 RGB Gesture Detection Module with APDS-9960 sensor
-- PAJ7620 9-gesture recognition sensor board
An additional small 35x45x15mm enclosure is suitable for mounting the DFRobot Gravity SEN0626: Offline Edge AI Gesture & Face Detection Sensor.
The stubs on the bottom of the enclosures have a 3.8mm hole for melting in M3 threaded inserts. The GY-9960 and PAJ7620 boards are secured with just one screw. The DFRobot Sensor can be secured at the corners with two or four M3 screws as desired.
My cheap Chinese Adafruit BME680 clone board was 100% compatible with the fischertechnik 'Environment Sensor' (nr. 182974) after pulling the SDO pin to ground to set the I2C address to 0x76 (default is 0x77)
More info about my projects can be found on my website whizzbizz.com