1 / 7
Replacement Foot for Niehoff TAPAS Chair – 20 mm Felt Pad, Ø30 mm Tube, 1 mm Wall Thickness — image 1
1 / 7

Replacement Foot for Niehoff TAPAS Chair – 20 mm Felt Pad, Ø30 mm Tube, 1 mm Wall Thickness

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Floor-friendly replacement foot for the Niehoff TAPAS chair with a flat contact surface for a 20 mm felt pad.

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
26
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution

Description

Floor-friendly replacement foot for the Niehoff TAPAS chair, featuring a flat contact surface for a 20 mm felt pad. It replaces the original rounded plastic glide and should also fit other chairs with a 30 mm tube diameter and a 40° leg angle.

Dimensions

  • Suitable for chair tubes with an inner diameter of approximately 29 mm

  • Flat contact surface for a 20 mm felt pad

  • Push-fit installation into the metal tube

  • No drilling or screws required

Print Recommendations

  • Material: PETG, ASA or ABS

  • PLA can also be used, but may deform more quickly under high loads or elevated temperatures

  • 4–5 wall loops

  • 20–30% infill

  • Print upright with the felt-pad surface on the build plate

  • No support structures required when using Arc Overhangs

  • Four pieces are required for one chair

After printing, attach a suitable felt pad to the bottom and press the foot into the metal tube. Depending on your printer, material and tube tolerances, slight scaling may be required.

Important Note About Overhangs

The model was printed with Arc Overhangs enabled. This allows the overhanging sections to be printed without conventional support structures.

If Arc Overhangs are not used or are not supported by your slicer, support structures must be enabled underneath the felt-pad contact area.

Tags