Creality K1 / K1C / K1 Max — Zero-Y-Loss Rear BTT Eddy Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Zero-Y-loss rear BTT Eddy mount for Creality K1/K1C/Max. Snug press-fit to stock tabs with clearance for all cables.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 35
- Makes
- 0
- Views
- 261
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Upgrade your Creality K1, K1C, or K1 Max with this low-profile, rear-mounted BTT Eddy probe holder.
Unlike many rear mounts that protrude past the back fo the toolhead and sacrifices precious Y-axis travel (or slam intot he rear frame) this deisgn is completely optimized for clearance. As seem in the assembly renders, the mount sits slightly inward of the stock extruder stepper motor, ensuring you lose absolutely zero Y-travel.
Features:
Stock Mount Integration: Slides directly into the back of the stock carriage using the two built-in tabs with small M2 holes
Dual Securement Options: The model prints as a precise, snug press-fit right off the plate. However, it includes internal geometry allowing you to add M2 threaded heat-set inserts if you want to lock it down permanently with screws.
Clean Cable Routing: Ample clearance is provided at the top and sides of the probe pocket for either the stock BTT USB cable or a custom cable wired intothe K1's native Lidar port.
Stealth Form Factor: Sits perfectly flush alongside the toolhead structure, maintaining the lseek look of the K1 carriage.
Klipper Config & Offsets:
Because this mount centers the probe perfectly behind the nozzle, the X-offset is completely zeroed out, maximizing your usable mesh area.
[probe_eddy_current btt_eddy]
x_offset: 0.0
y-offset: 24.3
# z_offset: Set this manually during calibration!
# (Will vary depending on your specific nozzle/ heatblock setup)Important Prtinting & Thermal Advice:
⚠ Thermal Notice & Turning:
I have stress tested this mount on long-running prints. even when printing ABS inside a closed 50°C chamber, the maximum recorded temperature on the Eddy probe reached 92°C. Because it gets hot back there, it is highly recommended to setup and calibrate the eddy at various different temps.
Recommended Print Settings:
Material: ABS, ASA, or PC (Highly recommended due to proximity to the stepper motor and heatblock). Do not use PLA or PETG.
Walls/Perimeters: 3 or 4
Infill: 25% to 40% (Grid or Gyroid for rigidity)
Supports: Only required for the overhang overhangs/pockets depending on your printer's bridging capabilities. Keep your support interfaces clean to ensure the press-fit tabs stay tight!