1 / 6
HP Pavilion 250 G6 (3168N6W) Laptop: Desktop Conversion — image 1
1 / 6

HP Pavilion 250 G6 (3168N6W) Laptop: Desktop Conversion

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A laptop motherboard enclosure for use as a desktop.

Rating
0 / 5
Likes
5
Downloads
33
Makes
0
Views
250
Reviews
0

Updated at source:

Model information

Category
Computers
License
GNU General Public License v3.0

Part

Size (L*W)

Infill

Supports

Lid

214mm*193mm

>20%

Yes

Body/Base

208mm*186mm

>20%

No

Pwr Button

14.5mm Dia

>30%

Yes

Additional assembly parts:

  • HP 250 G6 laptop motherboard w/ heatsink, RAM installed

  • M.2 2280 SSD

  • HP wireless card w/ antennas (863934-855, DC330020910, optional)

  • Power button board w/ ribbon cable (924994-001)

  • DC jack (799749-S17)

  • HP cooling fan (925012-001)

  • 9 M1.8*3mm screws

  • 5 M1.8*10mm screws 

  • 4 self adhesive rubber feet

Note: other sizes of screws can be used if you adjust the hole diameter via the Onshape model

Assembly instructions (use photos as reference):

  1. Place the pwr button in the circular cutout on the body. Make sure to face the extruded edge towards the antenna cutouts/IO

  2. Place the power button PCB on top of the power button, slotting the alignment pin into the hole on the PCB

  3. Screw 2 3mm screws into the 2 holes close to the power button. One of them does not pass through an accompanying hole, this in intentional.

  4. Attach the ribbon cable to the power button PCB

  5. Place the motherboard onto the base, lining it up with the alignment pins

  6. Use 5 3mm screws to secure the motherboard in place, and 1 to secure the SSD in place (near the RAM slots).

  7. Connect the other end of the ribbon cable to the motherboard; you will have to tuck it under the motherboard. It should run parallel with the edge of the heatsink

  8. If using, place the antennas into their cutouts. Hot glue may be necessary if the antennas did not come with adhesive. use a 3mm screw to secure the WiFi card to the motherboard, and connect the 2 antenna cables to it

  9. Rotate the fan so that the exhaust is facing the heatsink as shown in the photo, and align the top hole with the matching alignment pin, placing it on top of the standoffs. The fan is is held in place by the lid, and is not attached with screws. Plug the fan cable into the adjacent header

  10. Slot the power jack into the lid; It may be loose fitting. Use a small piece of rubber/plastic to fill space if needed. Attach its connector the the header close the the WiFi card slot.

  11. Place the lid onto the main assembly, and use all of the 10mm screws to secure everything together

  12. Add the 4 rubber feet to the bottom 4 corners of the assembly to allow adequate airflow underneath.

To edit the model or export in different formats, use this Onshape link:

https://cad.onshape.com/documents/0a88ef8a074bf17da84d735e/w/598dd69d99028b65a0777047/e/facfdb0901ba5c552db6b701?renderMode=0&uiState=6a3195028b8ca0ba07e6b203

Tags