Gopro Grip V1

This Gopro Grip/ Point and Shoot mount gives a professional look and incredible practicality! Prints in one piece and simply slides on to your GoPro cage with the option for a cold shoe mount and much more!

The Idea:

The idea for this mount came after looking at GoPros new Mission camera series and wanting my Gopro Hero 12 to look and feel like the Mission 1. the first step was the lens that was solved fast thanks to @boxcarsworld lens hood model mimicking the Mission 1 (found here ). But the Point and shoot accessory that was advertised with the Mission 1 was not found so easily, so I created my own and here we are. This is version 1 so there are many improvements that are needed but I wanted to get it out here first. For this version you will need this camera cage SmallrigGoproCage 

Any Camera that works with this Cage will work with this accessory 

Printing:

Orientation: flat the round grip facing up

supports: yes

Infill: 15%

Layer height: .2mm

Use:

to install place the bottom tab in at the bottom of the cage then bend the top half backwards until you can slide it into the cold shoe mount and then your good to GoPro!

Future versions: 

currently to use this you need the Small rig GoPro cage. But I fully intend to create a later version that is completely independent of the cage and can be used solely with the GoPro. Thanks for following this project and comment with any ideas or requests!

Thanks for your support!