Contact Microphone Case (Piezo)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just a small (5x5x1cm) Case for a 27mm Piezo Disk to use ist as a Contact Mic
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 22
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Open Community License v1.1 + Micro Business v1
Just a small (5x5x1cm) Case for a 27mm Piezo Disk to use ist as a Contact Microphone.
In the bottom is a 15mm hole to glue a magnet in, which also is used to ensure a direct connection between the ground an the piezo disk.
Additinal Material needed:
15x3mm Magner
27mm Piezo Disk
4x 3x12mm Screws (holes are 4mm ists not strict)
Cable with plug - XLR or TRS
The Nuts are a bit loose in the bottom part - i used a flat screwdriver to hold the nuts while tightening the screws.
Building: i just superglued the magnet to the piezo disk an than both into the bottom part. The cable get a strain relief through the curves.
The Model is inspired by :