Hydrophone Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Hydrophone case for a 27mm Piezo Disk
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Open Community License v1.1 + GAtt v1 + Micro v1
It's an encasement for a hydrophone. on the bottom is a 6mm hole for the cable, in the top a small edge to rest the piezo on.
I just used a Mic-cable, pulled it through the hole, used a cable-tie as a strain relief.
The case is than filled with quick-cement to add weight. ca 3mm unter the resting edge of the piezo is a small rim to mark the max fillig. it ensures that behind the piezo is some air to let t vibrate. Then super-glued the piezo disk in. Used some epoxy to seal the top.
On the side of the case is a small loop. There you can add additional weight or a stick or similar to turn it under water.