1 / 6
DRZ400 KLX400 3x3 Airbox Mod
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to clean up prior owner's poor cutting and allows you to add FrogzSkin hydrophobic mesh
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 93
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
The prior owner did a terrible job with the airbox mod. I ride off road and wanted more protection from water and dirt ingress. I'm adding Frogzskin hydrophobic mesh to the airbox opening.
If you can get the wires out of the way there's a single piece file. If not there are separate left/right pieces.
I used PETC-CF filament and applied with 3M VHB tape after preparing surfaces with adhesion promoter.
To glue/epoxy/bond in place be sure to prep the surfaces properly.