1 / 9
Odin 2 Portal - USB C Dock — image 1
1 / 9

Odin 2 Portal - USB C Dock

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Odin 2 Portal DIY Docking Station for external monitor/tv.

Rating
0 / 5
Likes
10
Downloads
50
Makes
0
Views
606
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Features & Design Notes

  • Designed specifically for the Odin 2 Portal with the original AYN Grip installed. The USB-C connector is intentionally positioned with approximately 2 mm of the connector housing exposed to compensate for the additional thickness of the grip around the USB-C port, ensuring proper docking without putting stress on the connector.

  • Integrated lock-in mechanism for the USB-C connector. The connector housing is secured by an internal retention clip that holds it firmly in place. No glue, silicone, epoxy, or other adhesives are required.

  • Built-in cable management. Excess USB-C cable from the hub can be routed through the bottom opening and stored neatly inside the dock, allowing the cable to remain loosely coiled without sharp bends, kinks, or unnecessary stress.

  • Two semi-circular front finger cutouts are integrated into the design. These allow you to hold the dock in place while removing the Odin 2 Portal, preventing the dock from lifting or sliding during undocking.

  • Side ventilation openings provide passive airflow around the USB-C hub, helping dissipate heat and preventing the enclosure from trapping warm air during extended use.

  • Very snug hub fit. The dock is designed around the dimensions of the USB-C hub linked below and holds it securely with a friction-fit design.

  • Optional M3 screw mounting holes. Two mounting holes are included to further secure the USB-C hub if additional retention is needed, although they may not be necessary depending on your printer tolerances and hub dimensions.

  • Supports I recommend to add supports manually on the slicer you are using only on the channel where the USB-C cable is routed and print it on its side

  • Rubber feet you can add 4 rubber feet of 8 mm diameter on the bottom to prevent from sliding.

Link to the USB-C Hub I used: https://www.aliexpress.us/item/3256811378546137.html?spm=a2g0o.order_list.order_list_main.29.4e8b1802e2Oenp&gatewayAdapt=glo2usa

Tags