1 / 3
Whistling Top, and Whistling Battle Top — image 1
1 / 3

Whistling Top, and Whistling Battle Top

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two spinning tops that are a new model, but are compatible with STLDenise's battle top launcher and contest.

Rating
0 / 5
Likes
21
Downloads
77
Makes
0
Views
457
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I was making a multimaterial top - that prints in one piece and can use interlocking, to just throw out a fully working spinning top that won't break apart as easily (in theory!) or need assembly. By constructing it this way it removes the common failure point of the pin. 

Technical advantages with this design:

  • Very low center of gravity. Much lower than the original. 

  • lifted base angle so it can wobble about a lot more without scuffing and losing momentum

  • Slanted fins, to flip over the opponent. Heh. 

  • Five fins because it looks cooler. 

  • A haunting whistle, maybe, if you spin it at the right speed. 

  • the base part can be 90% infilled for a REALLY mean heavy top. 

It's fully compatible with Denise's launcher, so please go there to print those out:

No tricks when printing - if you want single material, just turn on supports - bed plate only , if you want multimaterial, right click, split to PARTS, then select the middle bit and change filament. REMEMBER TO TURN ON BEAM INTERLOCKING or the parts wont mesh. 

Note: If the base of the top looks scruffy - do not be concerned. Nobody will see it. It seems to not affect performance, might even enhance it, who knows. 

Tags