EBB Base Board, Servo clamp and few washers for ExtruH
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A collection of small items I needed to build my own ExtruH.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 62
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Share Alike
Here are the extra small parts I needed :
B - Base to fit my EBB board, the raspberry pi 4 in official casing and cable management of all that. The EBB base board and wire clamp may be useful to you, I feel like the rest might be specific of my setup.
S - Servo clamp and washer to fit my MG90D servo motor
W - Washers I used, one for the driver pulleys, they are 8.5mm height and I wanted them to be perfect adjust in the 9.5 gap. And another one to have the rollers a bit off the plastic on the pen support.
Thanks Chris for all this, It is good fun and well working.