1 / 1
Holder/Stand for 120 mm fans with Noctua NV-AA1-12 Airflow Amplifier — image 1

Holder/Stand for 120 mm fans with Noctua NV-AA1-12 Airflow Amplifier

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I have modelled and build a holder/stand for use with 120 mm fans, in my case with a Noctua NV-AA1-12 Airflow Amplifier

Rating
0 / 5
Likes
1
Downloads
9
Makes
0
Views
144
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

I have modelled and build a holder/stand for use with 120 mm fans, in my case with a Noctua NV-AA1-12 Airflow Amplifier

This model also works perfectly without the Noctua part and you could show off a nice fan that way. Maybe something with lighting if you like that style. I decided to keep it clean and run with the technical style of the Noctua fan mod.

Important note on the fan:

This simple electric setup only works with 3-pin fans! With those, you can just use Plus and Minus/GND and have them runnig. 4-pin fans require more electrics.

Build instructions:

  1. Print all the parts

  2. Add heat inserts: M5 to the brackets, M4 in the base, M3 to the top plate

  3. The fan is mounted with 4 x M4 screws and nuts to its bracket, also add the fanguard if you want to, cover the nuts if you want

  4. Prepare the screws holding the fan in the bracket: Use M5 bolts, put them through the printed part, add two nuts to keep them securely in place

  5. Mount the brackets to the base, 2 x M4 screws for each bracket

  6. Set up the electrical part, figure out what is Plus and Minus on your fan beforehand! Connect Plus to the Switch and then to the fan, use shrink tube for better insulation...

    Important: Thread the fan wires through the top plate before assembling!

  7. Set the top plate down on the base, secure it with an M3 screw from the bottom, that screws into the M3 heat insert in the top plate...

  8. Done. Enjoy the breeze. :-)

Print instructions:

Pretty easy print. Use any material you like, 0.2 mm layer height with 15-20% infill. I used black PETG (except for the top plate – PETG was out, used black ABS).

Special parts used:

"Vormann Gardinenwinkel verzinkt 180/60 x 17 mm" – the metal brackets. Can be found here: https://www.globus-baumarkt.de/p/vormann-gardinenwinkel-verzinkt-180-60-x-17-mm-0763100040/

Also available in White: https://www.globus-baumarkt.de/p/vormann-gardinenwinkel-weiss-180-60-x-17-mm-0763100780/

(All white version of the print would probably look nice, too.)

Related model:

Video for this little project:

Tags