Radial Propagation Vase – Kit Card

ROSETTE
Radial Propagation Vase – Kit Card

Rosette is built around a radial structure that unfolds from the center outward.
Flat panels interlock to form a lightweight yet stable volume, defined by symmetry and openness.

Designed as a kit card system, the vase begins as a flat sheet and assembles in approximately three minutes. The transition from plane to form is integral to the design. Once assembled, it becomes a compact vessel for everyday plant propagation and water display.

Key Features

• Radial interlocking structure forming an open yet stable frame

• Kit card construction transforming from flat sheet to 3D form in minutes

• Lightweight yet structurally grounded geometry

• Compatible with Ø20 × 150 mm standard glass test tubes

• Available in Standard and Asanoha textured editions

Specification

Designed for a standard Ø20 mm × 150 mm glass test tube.

This size is widely available and easy to source.

Assembly

Step 1 — Install the Vertical Fins
Insert the vertical fins into the upper and lower radial rings to establish the structure.

Step 2 — Build the Radial Frame
Continue placing the fins evenly around the perimeter until the circular frame is complete.
You may install the full set for a denser, more defined form, or use fewer fins for a lighter and more open expression.

Step 3 — Insert the Glass Tube
Place the Ø28 × 150 mm glass test tube into the central opening.
The radial frame stabilizes the tube and lifts it slightly above the surface, allowing the plant to remain visually elevated.