Mini Flocertina - A mix of a Concertina/Accordion and a Recorder/Flute
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3D printed Concertina that uses flue pipes. I think I invented it. I'd like to make a 20 button version at some point.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 42
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Public Domain
Required Materials:
ALL-WEATHER DUCT TAPE (1.88 inch width)
SILICON TUBING (5/16" Outer Diameter, 3/16" Inner Diameter)
Optional Materials:
Gaffer Tape for the straps (Note: gaffer tape is not airtight enough to work well as bellows)
Main Parts required:
1 x Left Plate
1 x Left Inhale
1 x Right Plate
1 x Right Inhale
2 x Shell
24 x Card Bellows (3D printed or cardboard cutouts)
12 x Button
12 x Spacer
24 x flue pipes
12 x 1/4 inch long cuts of silicon tubing
20 yards of All Weather Duct Tape
Flue Pipes Notes recommended for Anglo Tuning (Bisonoric):
1 x C5
1 x D5
1 x E5
1 x F5
2 x G5
2 x A5
1 x B5_i
1 x B5_ii
2 x C6
2 x D6
2 x E6
1 x F6
1 x FS6
2 x G6
1 x A6
1 x B6
1 x C7
1 x D7
When printing, if a piece needs supports, use the "Touching Buildplate" setting.
Everything can be printed at 0.2mm thickness.
Steps:
Configure each of the 12 valves by inserting the plunger first, and pushing it through the hole before shoving the spacer and silicon tube as shown in the image below.

Then, push the "Inhale" pieces against the plates to form a pathway for air to flow through each valve.

Now, Insert the flue pipes using the Anglo tuning shown below.
Leave these ends for now.

Separately, lay out the card bellows as shown below.
Blanket eveything except the pointed edges in all-weather duct tape
Flip the whole thing over.

Blanket the other side in tape as well.
Tape the top edge on one side, and the bottom edge on the other.

Curl and fold the sheet so that it forms the bellows as the two ends meet.
This may require some patience to work through.

Tape any areas that require it.
Note: one end of the shell may need to face out to fit the ends nicely depending on how the print came out.
Tape the "Shell" pieces to the ends, both inside and out, so there are no air leaks.
Insert the ends into the shells with the "inhale" pieces on the inside.
Use more tape to attach them and make them as airtight as possible.
Create the straps using even more tape.
Note: I folded the edges of a thick strip of Gaffer Tape for the strap because I prefer the cloth texture it has.
Tape the straps to the shell using the all-weather duct tape.
You're done!
To play the instrument, hold down one or more buttons while pushing or pulling the bellows.

Here's a video of me attempting to play it:
